Example
This example displays information about the current VNS named VNS1:
WLC.siemens.com
:vnsmode:VNS1# show
WLANS service: wlan4
Non-authenticated: p4
Authenticated: same as non-authenticated
Restrict available role set: disable
Enable status: enable
Synchronize: enable
Name: VNS1
Common Filter Configuration Commands
The commands in this section are common to the configuration of both AP filters and AC filters. Each
filter must be configured in its own context (
on page 245 or
on page 245).
•
on page 268
•
on page 271
•
•
on page 273
create
Use the
create
command to create, insert, or append a new filter rule into an AP or AC filter list for a
<named-role>. The
create
command is accessible from within the vnsmode:<default-role>:acfilters
and vnsmode:<default-role>:apfilters contexts.
create [pos] proto protocol eth ether-type mac MAC address (ipaddress/mask |
interface-subnet | interface-ip | any) [(port port [port]) | (type-code type
[type])] in (none|src|dst|both) out (none|src|dst|both) (allow | deny | none |
contain2vlan vlan-id) priority (0-7 | none) tos-dscp (0-FF/(FF|FE|FC|F8|F0|E0|C0|
80)|none) cos (named cos|none) traffic-mirror (none) | enable | prohibited)
Parameters
pos
Specifies a position value for this filter in the filter list. Valid values are from 0 -
255.
proto
protocol
Specifies the protocol for this filter rule by number or name. Valid number values
are from 0 - 255. Valid name values are:
•
udp - UDP protocol
•
tcp - TCP protocol
•
ah - Authentication Header protocol
•
esp - Encapsulating Security Payload protocol
•
any- Any protocol
•
icmp - ICMP protocol
•
gre - Generic Route Encapsulation protocol
•
0-255 - number value of protocol
VNS Commands (vnsmode)
Common Filter Configuration Commands
SCALANCE WLC711 CLI Reference Guide
268
Summary of Contents for scalance WLC711
Page 1: ...SCALANCE WLC711 CLI Reference Guide Release V9 21 14 C79000 G8976 C261 07 Published July 2015 ...
Page 21: ...dns 2 192 1 2 3 dns 3 192 1 3 3 Common Commands show SCALANCE WLC711 CLI Reference Guide 21 ...
Page 376: ...Example topology Commands vlanid SCALANCE WLC711 CLI Reference Guide 376 ...