20
topology Commands
create
delete
internal-vlanid
multicast-support
show
<named-topology>
topology-group
This section describes commands used to define and configure topology objects used by policy and
VNS objects. These commands are located in the topology context of the CLI. Execute the
topology
command at the root level to enter topology context.
All CLI commands cache changes. For this reason, sometimes when you make a change in a particular
context, the change may not be visible immediately. If this happens, you must exit and re-enter the
context in order to ensure that the database is synchronized with the latest change.
The following commands are available in the topology context:
•
on page 340
•
•
•
•
on page 343
•
on page 343 for commands in the
topology:<named-topology> context.
create
Use the
create
command to create a topology object. The
create
command is accessible from the
topology context of the CLI.
create topology name (b@ac <vlanid> port port name tag | untag) | (b@ap vlanid
tag | untag) | (routed A.B.C.D/0-32) | (physical vlanid) port port nametag |
untag> A.B.C.D./0-32)
Parameters
topology name
Specifies the name of the topology.
b@ac
Specifies a Bridge Traffic locally at Controller topology.
b@ap
Specifies a Bridge Traffic locally at Access Point topology.
routed
Specifies a routed topology.
SCALANCE WLC711 CLI Reference Guide
340
Summary of Contents for scalance WLC711
Page 1: ...SCALANCE WLC711 CLI Reference Guide Release V9 21 14 C79000 G8976 C261 07 Published July 2015 ...
Page 21: ...dns 2 192 1 2 3 dns 3 192 1 3 3 Common Commands show SCALANCE WLC711 CLI Reference Guide 21 ...
Page 376: ...Example topology Commands vlanid SCALANCE WLC711 CLI Reference Guide 376 ...
