AirPrime WP8548 / WP75xx / WP76xx / WP77xx AT Command Reference
110
Proprietary and Confidential - Contents subject to change
4118047
!UDPID
Set/report product ID in USB descriptor
Use this command to set the device’s product ID in the USB descriptor. (Some devices may
support more than one product ID.)
Supporting devices:
WP75xx/WP8548. For WP76xx/WP77xx, use
.).
Password required:
Yes (see
for details)
Usage:
•
Execution:
AT!UDPID=<app product_id>
Response:
OK
Purpose:
Set the application ID in the USB descriptor.
•
Query:
AT!UDPID?
Response:
!UDPID:
<app_product_id>
OK
Purpose:
Report the product ID that is stored in the USB descriptor.
•
Query List:
AT!UDPID=?
Purpose:
Display a list of default (non-custom) product IDs for the device.
Parameters:
<app product_id>
•
Hexadecimal ASCII value.
•
Valid range: 0000–FFFF
!UIMREGSTATE
(notification)
UIM registration state—Unsolicited notification
Unsolicited notification indicating the UIM registration state of the active UIM interface,
received when the state changes. The active UIM interface is selected using AT!UIMS—see
on page 217 for details.
To enable !UIMREGSTATUS (and other notifications), use AT+WUSLMSK. See
on page 127 for details.
Notification format:
!UIMREGSTATE: <state>
Parameters:
<state> (UIM card registration state)
•
0—UIM not available
•
1—UIM available
•
2—UIM marked by network as invalid for CS services
•
3—UIM marked by network as invalid for PS services
•
4—UIM marked by network as invalid for CS and PS services
•
5—UIM is PIN1 locked
Table 3-2: Modem Status Command Details (Continued)
Command
Description
