AirPrime WP8548 / WP75xx / WP76xx / WP77xx AT Command Reference
172
Proprietary and Confidential - Contents subject to change
4118047
!DALSTXPWR
Set LTE Tx power level (LTE only)
Set the desired LTE Tx power level.
Note: This command cannot support a PUCCH waveform. (Waveform type is set using
!
Command Availability:
WP76, WP77. Valid in WP75xx/WP85xx Release 16 and later.
Password required:
Yes (see
for details)
Requirements:
Before this command can be used:
•
to enter FTM mode.
•
to set the device to an LTE band.
•
to set the uplink channel for the selected band.
•
to set the LTE Rx bandwidth.
•
to set the LTE Tx bandwidth.
•
to set the LTE Tx modulation type.
•
to set the LTE Tx waveform characteristics.
•
to set the LTE Net Sig value.
•
to turn the LTE transceiver PA on.
Usage:
•
Execution:
AT!DALSTXPWR=<enable>,<power_dBm>
Response:
OK
Purpose:
Set the LTE Tx modulation type.
Parameters:
<enable> (Enable/disable Tx power output)
•
0—Disable
•
1—Enable
<power_dBm> (Desired Tx power)
•
-57 to 23—Tx power in dBm
•
Field is ignored if <enable>=0
Table 6-2: Test Command Details (Continued)
Command
Description
