Rev.
6
Oct.18
Proprietary and Confidential - Contents subject to change
267
+WDSC (continued)
Configure AirVantage Management Services (continued)
Parameters:
<Mode> (Mode being configured)
•
0—User agreement for AVMS connection. When enabled, the module returns an
unsolicited notification to request an agreement before connecting to the server. See
on page 270 for details.
Note: If a FOTA session begins and user agreement for package download (<mode>
1) is disabled, an AVMS connection is initiated, regardless of whether user agreement
for AVMS connection (<mode> 0) is enabled or disabled.
•
1—User agreement for package download. When enabled, the module returns an
unsolicited notification to request an agreement before downloading any package. See
on page 270 for details.
•
2—User agreement for package install. When enabled, the module returns an
unsolicited notification to request an agreement before installing any package. See
on page 270 for details.
•
3—Polling mode. When enabled (<State> > 0), the module waits for the number of
minutes specified in <State>, then will initiate a connection to the AirVantage server
based if the device is registered on the network.
•
4—Retry mode. If an error occurs during a connection to the AirVantage server (e.g.
WWAN DATA establishment failed, http error code received), the module will initiate a
new connection according to the defined timers. (Note: This is a persistent setting.)
•
5—User agreement for device reboot. When enabled, the module returns an
unsolicited notification to request an agreement before rebooting the device. See
on page 270 for details.
•
6—User agreement for application uninstall (software update). When enabled, the
module returns an unsolicited notification to request an agreement before uninstalling
an application. See
on page 270 for details.
<State> (For <Mode> = 0, 1, 2, 5, 6: Activation state of <Mode>)
•
0=Disabled
•
1=Enabled
<State> (For <Mode> = 3: Activation state/timer of <Mode>)
•
0=Disabled
•
1–525600=Polling timer (in minutes)
<Timer_1>..<Timer_n> (Connection attempt interval timers)
•
The number of minutes to wait after connection attempt (n-1) before making
connection attempt (n). (Note: There is a maximum of 8 connection attempts.)
•
Valid range: 1–20160
•
Default values:
•
<Timer_1>=15 (Time to wait after first failed connection attempt.)
•
<Timer_2>=60 (Time to wait after second failed connection attempt.)
•
<Timer_3>=240 (Time to wait after third failed connection attempt.)
•
<Timer_4>=960 (Time to wait after fourth failed connection attempt.)
•
<Timer_5>=2880 (Time to wait after fifth failed connection attempt.)
•
<Timer_6>=10080 (Time to wait after sixth failed connection attempt.)
•
<Timer_7>=10080 (Time to wait after seventh failed connection attempt.)
Table 14-2: AirVantage Device Services Command Details (Continued)
Command
Description
