19
[Description]
Turn white/black reverse printing mode
。
•
When the LSB of n is 0, white/black reverse mode is turned off.
•
When the LSB of n is 1, white/black reverse mode is turned on.
[Note]
•
Only the lowest bit of n is valid.
•
This command is available for built-in characters and user-defined characters.
•
When white/black reverse printing mode is on, it also applied to characterspacing
set by ESC SP.
•
This command does not affect bit image, user-defined bit image, bar code,
HRIcharacters, and spacing skipped by HT, ESC $, and ESC \.
•
This command does not affect the space between lines.
•
White/black reverse mode has a higher priority than underline mode. Even
ifunderline mode is on, it is disabled (but not canceled) when white/black
reversemode is selected
[Defaults]
n=0
GSHn
[Name]
Select printing position for HRI characters
[Format] ASCIIGS H n
Hex
1D48n
Decimal
29 72 n
[Range]
0
≤
n
≤
3,48
≤
n
≤
51
[Description]
Selects the printing position of HRI characters when printing a bar code.
n select printing position as follow
:
n
Printing position
0,48
Not printed
1,49
Above the bar code
2,50
Below the bar code
3,51
Both above and below the bar code
•
HRI indicates Human Readable Interpretation.
[Note]
•
HRI characters are printed using the font specified by GS f.
[Defaults] n=0
[Reference] GS f,GS k
GSLnLnH
[Name]
Set left margin
[Format] ASCIIGS L nLnH
Hex1D 4C nLnH
Decimal
29 76 nLnH
[Range]
0
≤
nL
≤
255
0
≤
nH
≤
255
[Description]
Sets the left margin using nL and nH.
•
The left margin is set to
[(nL+nH
¬
256)¬0.125mm]
。
[Note]
•
This command is effective only processed at the beginning of the line
instandard mode.
•
If the setting exceeds the printable area, the maximum value of
the printablearea is used.