N E T W O R K C O N F I G U R A T I O N V I A T E L N E T
Rev H
174 of 244
Command Syntax
IPG.Config.Network >
set ipgateway A.B.C.D
IPG.Config.Network >
no set ipgateway
IPG.Config.Network >
se ipg A.B.C.D
IPG.Config.Network >
no se ipg
Argument Description
A.B.C.D
IP address of the default gateway.
19.2.5 Setting the IP Address of the DNS Server
The
set ipdns
command, in Network Configuration mode, sets the primary DNS ServerIP
address. The
no
form of the command removes the IP address.
Command Syntax
IPG.Config.Network >
set ipdns A.B.C.D
IPG.Config.Network >
no set ipdns
IPG.Config.Network >
se ipd A.B.C.D
IPG.Config.Network >
no se ipd
Argument Description
A.B.C.D
IP address.
19.2.6 Setting the Automatic Configuration ID
The
set id
command, in Network Configuration mode, sets the Automatic Configuration ID.
The
no
form of the command removes the DHCP Automatic Configuration ID.
The Gateway will run the configuration file only if the file name or ID is different from the
ones currently stored in the Gateway.
If the ID in the Config file or on the DHCP server is set to the literal value “always”, the
configuration file is executed on every boot without comparing to the ID stored in the
Gateway.
By default, the configuration ID is set to zero (0).
Command Syntax
IPG.Config.Network >
set id
STRING
IPG.Config.Network >
no set id
IPG.Config.Network >
se id STRING
IPG.Config.Network >
no se id
Argument Description
STRING
The Automatic Configuration ID.
Summary of Contents for AC - 232 - TX
