Programming Manual
–
T3AWG3K-C Series Arbitrary Waveform Generator
True-Arb Operating Mode
28
Command
Description
AWGControl:RSTATe?
Returns the state of the
arbitrary waveform generator.
AWGControl:RUN[:IMMediate]
Initiates the output of a
waveform or a sequence
AWGControl:SREStore
Opens a setup file into the
AWG’s setup memory
AWGControl:SSAVe
Saves the AWG's setup with
waveforms
AWGControl:STOP[:IMMediate]
Stops the output of a
Sequence
AWGControl:WAITstate
Sets or returns the Wait Trigger
On parameter
AWGControl:JUMPMode
Sets or returns the Jump Mode
parametes
AWGControl:DJStrobe
Sends the pattern strobe event
Table 14: Control group commands
2.9.2
Calibration and Diagnostic
Command
Description
CALibration[:ALL]
Performs a full calibration of
the AWG. The query form
performs a full
calibration and returns a status
of the operation.
DIAGnostic[:ALL]
Performs the self diagnostic
procedure.
Table 15: Calibration and Diagnostic group commands
2.9.3
Output Group Commands
Use the following output commands to set or return the characteristics of the output port of
the arbitrary waveform generator:
Command
Description