microMIND V2 Signal
Interpreter and Configuration
The microMIND V2 signal interpreter allows the configuration of simple pattern
matching rules. These include multi-click and clock driven events while observing
multiple I/O port pins in parallel.
microMIND V2 .INI Configuration
[PORTS]
The Digital Input Port can be configured in the a .INI file on the microMIND. The general
configuration is in the [PORT] section as follows:
▪ REVERSE - Set to 1 if the bit order of the I/O port pins shall be reversed, e.g. b101000
▪
instead of b000101. Otherwise, set to 0. This means that for example the port pin
previously addressed as [DIPORT0] would then be addressed as [DIPORT5].
▪ INVERT - Set to 1 if the bits on the I/O port pins shall be inverted, e.g. b001000
▪
instead of b110111. Otherwise, set to 0.
[DIPORTn]
Each pin on the I/O port can be configured under [DIPORT0] ... [DIPORT5]. The following
settings are available:
Interpreter Parameters
▪ DEBOUNCE - The number of milliseconds after a signal edge has been detected, to
▪
suspend monitoring. Helps to solve double-click problems because of signal bouncing.
▪ TIMEOUT - period since last edge after which an open multi-click sequence is
▪
terminated. A multi-click sequence is regarded as open after the first matching event.
▪ EDGE - 0 for valid signal event on rising edge, 1 for falling edge, 2 for both edges.
▪
▪ RULEn - defines rules for pattern matching as explained below. n may be within 1 to
▪
16. The sequence must be continuous or the rules won't be used after the
discontinuity. For example, if RULE1, RULE2, RULE3, RULE5 are defined, only RULE1, 2
and 3 will be used.
Interpreter Rules
Different Rules can be defined for each port pin in the respective [DIPORTn] sections.
Rules must be defined under the port which holds the clock signal in order to trigger
port events. The rule format is
RULE{number}={product}: {mask}, {pattern}, {counter}, {clicks} where
17
microMIND V2 Signal Interpreter and Configuration
8
8.1
Summary of Contents for microMIND V2
