Advent Instruments Inc.
3. HAL Properties
Name:
SYSTEM.FLAGSET
ID:
15
Type:
Numeric - w/o
Description:
Sets one or more interrupt bit(s). By writing an integer value to this property, each bit set
in the value sets the corresponding bit in the system interrupt register. See FLAGCLEAR
for a listing of all assigned interrupt bits.
Name:
SYSTEM.HALID
ID:
3
Type:
String - r/o
Description:
Returns a string representing the hardware abstraction layer currently used by the
firmware. The version numbers are enclosed in [ ] brackets.
Name:
SYSTEM.HALTCMDS
ID:
17
Type:
Numeric
Description:
Enables or disables command processing from either the serial RS-232 port or the USB
port according to the following values:
0 = Command processing from both serial and USB is enabled
1 = Command processing from serial port is disabled
2 = Command processing from USB port is disabled
3 = Command processing from both ports is disabled.
Note, if a line break is detected on the serial port then command processing will be
resumed (if currently disabled). If the USB port goes into reset or is un-plugged, then
command processing is resumed (provided the USB port status indicates it is enumerated
by the PC).
Name:
SYSTEM.OPTIONS
ID:
18
Type:
Numeric - r/o
Description:
Returns an option code. The code may represent hardware or software options that are
enabled or present. At this time no options are defined.
Name:
SYSTEM.RESET
ID:
11
Type:
Numeric - w/o
Description:
Writing any value to this property causes a reset of the AI-7280. All properties are
returned to their power up default value.
AI-7280 Programmers Guide - Direct Control
59
