-INT5
SO5
-INT
SO
SCK
-RST
+3V3
+5V
CLKO5
-WOL5
CLKO
-WOL
SI
-CS
GND
GND
uPC
MSEL
MOSI
-INT1
-INT0
MISO
MCLK
VDD GND
GND
+5V
100nF
SPINET
5V application
3. SOFTWARE
An example program in C is available at
www.asix-tools.com
royalty free. The
module may be purchased as a set for easy connection to PVK40 development
board.
Description of communication with ENC28J60 is available in the datasheet and
application notes of its manufacturer.
A suitable
MAC address
shall be assigned to the module during startup
configuration of ENC28J60. If yo are not assigned Organization unique
identifier (
OUI
) by
IEEE
, it is recommended to use an address from locally
administered range, that is, an address with bit 1 (second least significant) in
its first byte set, e.g. 02-00-00-00-00-78.
Note: The module provides with solution of communication over Ethernet
network up to the MAC layer, that is, it transfers Ethernet frames. Higher level
protocols (ARP, IP, ICMP, UDP, TCP, HTTP...) are to be implemented in the
application (typically in the firmware of connected microcontroller).
Page 5
