Single Plug-in Card Matrix Switcher
16
www.av-box.ru
6.2 RS232 Communication Commands
Case insensitive.
In following
commands, “[”and “]” are symbols for easy reading and do not need to
be typed in actual operation.
Type in the complete commands including ending symbol
“.” or “;”.
For input/ output channels 1~9 in the commands, type in 01~09 instead of 1~9.
After sending command
“%0911.” to restore factory default, wait for 10s or so before
you reboot the device. Or the restoration may fail, and it will prompt
“Default failed,
please try again!” in the feedback.
Communication Protocol
: Baud rate: 9600; Data bit: 8; Stop bit: 1; Parity bit: none.
Command
Description
Feedback
System Command
/*Type;
Inquire the model
FMX16
/%Lock;
Lock the front panel buttons
System Locked!
/%Unlock;
Unlock the front panel buttons
System Unlock!
/^Version;
Inquire the firmware version
VX.X.X
/:MessageOff;
Turn off the feedback from the com
port. It only shows
“switcher OK”.
/:MessageOff;
/:MessageOn;
Turn on the feedback from the com
port.
/:MessageOn;
Operation Command
Undo.
Cancel the previous operation.
Undo Ok!
Demo.
Switch to the “demo” mode, 02->01,
2->2, 3-
>3 … and so on.
Demo Mode
AV: 02-> 01
……
[x]All.
Transfer signal from Input [x] to all
outputs
02 To All.
All@.
Switch on all the outputs
All Open.
All$.
Switch off all the outputs
All Closed.
[x]@.
Switch on output [x]
02 Open.
[x]$.
Switch off output [x]
01 Closed.
