BEKA BA526C, Manual

26

Display      Description of function

'Add'

Add a break-point

Adds a new break-point before the
displayed break-point. The calibration
of existing break-points is not changed,
but

the

identification

number

of

subsequent

break-points

is

incremented.

'dEL'

Remove a break-point

Removes the displayed break-point
and joins the preceding break-point to
the following break-point with a straight
line.

The identification of subsequent

break-points is decremented.

'inPut' Defines the current at which break-

point occurs

Enables the required current at each
break-point to be defined without
having to input an accurate input
current to the indicator.

'diSP'

Defines display at break-point

Enables the indicator display at each
break-point to be defined.

Select 'SEt' from the main menu and press

P

once

to enter the 'Add' function, and again to reveal the
current and total number of break-points.

Each

subsequent operation of the

P

push-button will

introduce an additional break-point. When adding
a break-point to a calibrated indicator, the insertion
position can be selected using the

Up

and

Down

push-buttons.    

The delete break-point function 'dEL' operates in a
similar manner to the 'Add' function described
above.

When the required number of break-points has
been entered, return to the sub-menu by pressing

E.

The indicator will display 'Add' or 'dEL'

depending upon the last function used.

The

required indicator display at each break-point can
now be entered, followed by the input current at
which each break-point occurs.  

To enter the required display at any break-point
select 'dISP' from the sub-menu and press

P

which

will select the first break-point '0 n', where 'n' is the
total number of break-points selected.

The

selected break-point can be changed using the

Up

and

Down

buttons. When the required break-point

has been selected press

P

to reveal the existing

display. Using the

Up

and

Down

buttons and

P

to

move between digits set the revised display.
Press

E

to return to the sub-menu from which

another break-point can be selected. Repeat this
procedure for all the break-point displays to be
changed, and then return to the 'diSP' prompt in
the sub-menu by pressing

 E.

To enter the input current at which each break-
point occurs select 'InPut' from the sub-menu and
press

P

which will select the first break-point '0 n'.

The selected break-point can be changed using
the

Up

and

Down

buttons.

When the required

break-point has been selected, press

P

to reveal

the input current at which the break-point occurs.
Using the

Up

and

Down

buttons and

P

to move

between digits, set the revised input current in mA.
Press

E

to return to the sub-menu from which

another break-point  can be selected.   

Repeat this procedure for all the break-point input
currents to be changed, and then return to the
'InPut' prompt in the sub-menu by pressing

 E.