Host Commands
Polycold Cryochiller
System Operational State Commands
Installation and Operation Manual
Brooks Automation
7-22
214072 Revision B
CAPACITY_TARGET_TEMP Cooling Capacity Target Temperature
POWER_MGMT_STANDBY_DELAY Excess Capacity Temperature difference
Purpose:
Get/Set the target temperature used to define the normal capacity for non-tem-
perature controlled cooling modes to engage power management mode.
Monitor Data:
Refrigerant Return temperature
Parameter(s):
? or [nnnn]
[nnnn] is target temperature
Return Value:
[A] or [A][nnnn]
Data Type:
Integer
Default Value:
-120
Min: -190
Max: -70
Units:
Degrees Celsius (signed)
Security Level:
Get: 1
Set: 3
Example:
“CAPACITY_TARGET_TEMP,?” Get the normal cooling capacity target temper-
ature.
Interface
RS-232, Ethernet
Purpose:
Get/Set Power Management Standby Mode delay time
Monitor Data:
Time
Parameter(s):
? or [nnnn]
[nnnn] is delay in seconds
Return Value:
[A] or [A][nnnn]
Data Type:
Integer
Default Value:
1200
Min: 1
Max: 36000
Units:
Seconds
Security Level
Get: 1
Set: 3
Example:
“POWER_MGMT_STANDBY_DELAY,?” Get the power management
delay
Interface
RS-232, Ethernet
