Data Input
The input data is in the form of new System and Label Formatting commands. The system level commands consist
of Database and Direct User Interface.
Database setup commands <STX>KcRI and response data <STX>KcQQQ support the entries that are shown in the
Operator’s Menu interface.
STX
KcRIa
RFID Configuration
RI
M, A, D, S,
L, R, W, E, P
See Table Below.
Printer Options
(RF) RFID Configuration –
This command configures the optional RFID interface module as follows:
Value
Range / Interpretation
M, A, D, S, L,
R, W, E, P
Mn - Mode (enables RFID module detection by the printer):
Where n is:
D - disabled (RFID disabled); N is also a valid disabler
U - UHF (915mhz)
H - HF (13.56mhz)
(HF) - Ahhl - Application Family Identifier (AFI); where hh is 2 Char Hex ID & l is Lock after
write (E-Enable /D-Disable)
(HF) - Dhhl - Data Storage Format Identifier (DSFID); where hh is 2 Char Hex ID & l is Lock
after write (E-Enable /D-Disable)
(HF) - Shh - Electronic Article Surveillance (EAS) Set; where hh is 2 Char Hex ID representing
manufacturers code
(UHF) - Lhh – Lock Code; where hh is 2 Char Hex ID
Rn - Number of retries (n = 0 to 9)
Wn – Lock after write; where n is: (E-Enable /D-Disable)
En – Erase (erase tag) on error; where n is: (E-Enable /D-Disable).
Pxxx - Position. Currently if value is 0.00 print position is used to encode tag. If > 0.00
presented position is used.(Subject to change.)
RFID Configuration Set Commands
Example:
<STX>KcRIMH;RIA11E;RID22E;RIS04;RIR3;RIWE;RIEE;RIP000<CR>
The above example sets the printer to HF, protect after write AFI 11, protect after write DFSID 22, set EAS Bit
(Mfg. Code 0x04), allow 3 tries for each read or write attempt, lock after write and erase the tag if there is an error
and position of 0.00.
STX
KcOFa
Option FeedBack
OF
D, Rx, S
See Table Below.
Printer Options
(OF) Option Feedback Mode –
This command configures the printer to output the status of the RFID
operation to the current port. See Data Output section for details of the response.
Value
Range / Interpretation
D, Rx, S
D - Disable
R - RFID Enable, where x = A - ASCII Response, x = H - Hexadecimal response
S - Scanner Enable