User Manual DEV 1953
118
Copyright DEV Systemtechnik GmbH 2015-2017
5.9.4.3.3
.application.simultaneousMode
OID:
.1.3.6.1.4.1.21035.41.2.3
.0
Syntax:
INTEGER {simultaneous (1), individual (2)}
Access:
read-write
Description:
The switching mode (please refer to chapter 5.1.4), possible values:
"
1
" in Simultaneous switching mode all switch modules being
member of a group (defined by .swGroupMembers (chapter
5.9.4.3.5.2)) are switched synchronously if one member of
the group is switched via .swPosition (chapter 5.9.4.3.7.4) of
the .switchUnitTable
"
2
" in Individual switching mode all switch modules can be
switched independently
Note:
.simultaneousMode cannot be set to "
1
" if the switch modules within all groups
with two or more members are not in the same switch position (chapter 5.1.4).
5.9.4.3.4
.application.numberOfSwitchGroups
OID:
.1.3.6.1.4.1.21035.41.2.4
.0
Syntax:
INTEGER32
Access:
read-only
Description:
The number of switch groups.
For this type of device "
16
" is returned.
Note:
For .numberOfSwitchUnits "
16
" is returned independently whether the device
is equipped with sixteen or less switch modules.
This value is used to determine the maximum index of the following table:
5.9.4.3.5
.application.switchGroupTable
"
16
" is returned for .numberOfSwitchGroups (please refer to chapter 5.9.4.3.4),
thus a corresponding number of entries per .switchGroupTable OID. The table is
used for the assignment of switch units (here: switch modules) to groups which is
required for simultaneous switching applications.
5.9.4.3.5.1
.application.switchGroupTable.switchGroupEntry.swGroupIndex
OID:
.1.3.6.1.4.1.21035.41.2.5.1.1
.x
Syntax:
INTEGER32 (1..32)
Access:
not-accessible
Description:
A unique value for each table entry ranging between "
1
" and the
number of entries (defined by .numberOfSwitchGroups, please
refer to chapter 5.9.4.3.4).
