XMP 240 C AT • Remote Control and Configuration
122
Command and Response Table for DSP SIS Commands
Command
ASCII command
(host to device)
Response
(device to host)
Additional description
Audio level control
NOTE:
The command format is the same regardless of the control point, but the acceptable gain range varies
depending on the control point.
•
The mic/line input gain range is
-18
dB to
+24
dB in
0.1
dB increments when the source is set to a digital
input (for more on changing the input source, see
•
The pre-mixer gain and virtual return gain range is
-100
dB to
+12
dB in
0.1
dB increments.
•
The post-mixer trim gain range is
-12
dB to
+12
dB in
0.1
dB increments. Post mixer trim cannot be muted.
•
The output attenuation gain range is
-100
dB to
0
dB in
0.1
dB increments.
•
All responses are shown with the XMP 240 C AT in Verbose mode 2 or 3.
Set gain level
E
G
X7@
*
X7#
AU
}
DsG
X7@
*
X7#]
Set gain on OID
X7@
to a
value of
X7#
dB.
Example 1
(input 1):
E
H40000*120
AU
}
DsH40000*120
]
Set the input 1 to a level of
+12.0 dB.
Example 2
(pre-mixer gain 1):
E
G40100*-8
AU
}
DsG40100*-8
]
Set pre-mixer gain 1 to a
value of -0.8 dB.
Read gain level
E
G
X7@
AU
}
DsG
X7@
*
X7#]
Gain on OID
X7@
is set to a
value of
X7#
dB.
Example 1
(input 1) :
E
H40000AU
}
DsH40000*25
]
Input 1 gain is set to a
value of +2.5 dB.
Example 2
(post-mixer gain 1) :
E
G60100AU
}
DsG60100*55
]
Output 2, post mixer gain
is set to a value of +5.5 dB.
NOTE:
Use the
H
parameter instead of the
G
parameter when setting or reading digital input gain level (for
more on changing the input source, see
Audio Mute
Audio mute
E
M
X7@
*1AU
}
DsM
X7@
*1
]
Mute audio at
X7@
.
Audio unmute
E
M
X7@
*0AU
}
DsM
X7@
*0
]
Unmute audio at
X7@
.
Mute status
E
M
X7@
AU
}
DsM
X7@
*
X7$]
KEY:
X7@
=
Target OID
See
X7#
=
Gain value
Levels use a 10x multiplier system with no decimal spaces. For
example, a level of +10.4 dB would be entered as
104
and a
level of -3.2 dB would be entered as
-32
.
X7$
=
Mute status
0
= disabled
1
= enabled
