C
ONFIGURATION
C
OMMAND
S
ET
- F
IRMWARE
R
EVISION
2.4.0_
BETA
-
V
ERSION
1.0.0
3.2.1.2.3
Sys.RUpdate.Finish – Finishes Remote Update
Command syntax
Sys.RUpdate.Finish
Examples
$PFAL,Sys.RUpdate.Finish
Message description
In case of a successful firmware update, the device will perform a reset and starts
with the updated firmware after approx. 30-40 seconds (depending on the size of
the firmware).
Parameter description
None.
Note:
•
All data required for the firmware update has to be specified and verified
using checksum commands before executing this command.
•
For
"FW_raw"
type:
If the finish command fails, note that after resuming the firmware update
later, a previously transmitted
configuration
will be
always erased
.
This doesn't matter in case the old firmware configuration is used (option
keep_cnf
), but in case it was transferred (option
clear_cnf
), it
MUST be
transferred again
before finishing the update.
Else the device will be unreachable (because it will start using default
settings).
•
In case the firmware update was resumed, note that a previously transmitted
configuration will be always erased. This doesn't matter in case the old device
configuration is used, but in case it was transferred, it
MUST
be transferred
again before finishing the update procedure. Otherwise the device will be
unreachable (because it will start with default settings)
•
This command doesn't create a PFAL answer if successful executed (just in
case of an error).
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 37 of 271