34
[Sysname] interface ten-gigabitethernet 2/2/0/2
[Sysname-Ten-GigabitEthernet2/2/0/2] port link-aggregation group 2
4.
Configure Device C as the intermediate device:
CAUTION:
If the intermediate device is also an IRF fabric, assign the two IRF fabrics different domain IDs
for correct split detection. False detection causes IRF split.
# Create a dynamic aggregate interface.
<Sysname> system-view
[Sysname] interface route-aggregation 2
[Sysname-Route-Aggregation2] link-aggregation mode dynamic
[Sysname-Route-Aggregation2] quit
# Assign Ten-GigabitEthernet1/0/1 and Ten-GigabitEthernet1/0/2 to the aggregate interface.
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] port link-aggregation group 2
[Sysname-Ten-GigabitEthernet1/0/1] quit
[Sysname] interface ten-gigabitethernet 1/0/2
[Sysname-Ten-GigabitEthernet1/0/2] port link-aggregation group 2
Example: Configuring a BFD MAD-enabled two-chassis IRF
fabric
Network configuration
, set up an IRF fabric at the distribution layer of the network.
•
Configure BFD MAD in the IRF fabric and set up BFD MAD links between the member devices.
•
Disable the spanning tree feature on the ports used for BFD MAD, because the two features
conflict with each other.
•
Assign the highest member priority to Device A so it can be elected the master.
Summary of Contents for MSR 5600
Page 7: ...ii...
