Janus G3, User Manual

List of Commands for Programming Mode 

NOTE:

 The phone enters Programming Mode after completing step 2 

of the Programming Instructions.

• #0 First Phone Number *# 

• #1 Second Phone Number *# 

• #2 Third Phone Number *# 

• #3 Fourth Phone Number *# 

• #4 Identification Code *#

• #5 Programming New Password *# - Set Programming Access Code 

• #7 - Records location message  

• #8 - Plays back location message  

• #* 1 XXX Y W Z *# - setup code (Default is: #* 1 180 1 8 3 *#)

           • XXX - Call Timer [000,060-990], 000=Disable timer

           • Y - Push Button Control [0-2]

  [0] Push on = turn on/push again = play message

                  [1] Push on = turn on/push again = turn off

                  [2] Push and hold = turn on/release = turn off

                  [3-8] Push and hold to turn on for 

Y

 amount of seconds to make 

                          a call. If pushed for less than 

Y

 amount of seconds, turn 

                          off/push again = turn off

           • W - Unit ID [1-8]

           • Z - Voice Mode [0,3 or 5]

• **42 X *# - Ring Count (for incoming calls) (0-9 range, 4 = default, 0 = no 

                    answer)

• **43 X *# - Ring Time (for outgoing calls) (18-60 range, 50 is default) 

•**44 X *# - AUX1 behavior (0-2), 0 = disabled, 1 = red led, 2 = green led, 

                   3 = VCC mode  

• **45X*# - Redial, 0 = disabled (Default), 1 = Dial the number 1 more time, 

                  2 = Dial the number 2 more times

• **8 XX *# - Set Language (1 = English: default, 2 = Spanish, X= [1-2] 

                    (must have 2 digits)  

NOTE:

 **8XX*# will play both messages according to the order specified.

(Ex// **812*# = English then Spanish or **821*# = Spanish then English) 

NOTE:

 If second message is not used, enter ʻ0ʼ for that message. For

example, if you want to set to play English only you must program: **810*#.

• **7 0 *# - Ring-Thru Converse Mode (Default). With this setting, the G3 

will automatically enter two way communication after it has answered an 

incoming call.  

• **7 1 XXXX *# - Hang Up Converse Mode - Set Remote Access Code. 

NOTE:

 When user calls in they have 5 seconds to enter the 4 digit 

password set by *71. If not or the wrong code is entered, a long beep 

will be heard and the phone will turn OFF. If the correct code is entered, 

3 beeps will be heard and two way communication will be established. 

The speaker and microphone will both be muted until the correct code is 

entered.  

10