Section 8: Keithley User Library Tool (KULT)
Model 4200A-SCS Parameter Analyzer Reference Manual
8-26
4200A-901-01 Rev. C / February 2017
Building the user library to include the new user module
After you have successfully compiled the user module, build the user library (or rebuild the user
library) to include the module.
To build the user library:
1. Select the Build tab.
2. From the
Options
menu, select
Build Library
. The following occurs:
The user library is built. All of the user modules in the presently open user library, and any
libraries on which the presently open user module depends, are linked together.
A DLL is created that is accessible using UTMs in Clarius.
The KULT Build Library message box indicates the build progress. If linker problems are
encountered, this message box displays error messages. When you build the
TwoTonesTwice
user module, you should see no errors.
When the KULT Build Library message box closes or if there are error messages when you click Ok,
the Build tab area displays either of the following:
•
If the compilation was successful, this message appears:
No Errors/ Warnings Reported,
Library Build was Successful
.
•
If the compilation was unsuccessful, error messages, if any, that were displayed in the KULT
Build Library message dialog box also display in the Build tab area in red.
(on page 8-26).
Finding build errors
Find build errors using the information in the error message.
(on page 8-26).
Checking the user module
To check a user module, you need to create and execute a user test module (UTM) in Clarius. Create
a simple Clarius project to check the user module.
To check the user module in Clarius:
1. Start Clarius.
2. Choose the
Select
pane.
3. Select
Projects
.
4. Select
New Project
.
5. Select
Create
. You are prompted to replace the existing project.
6. Select
Yes
.
7. Select
Rename
.
8. Enter
UserModCheck
and press
Enter
.
9. Choose
Select
.
10. Select the
Actions
tab.
11. Drag
Custom Action
to the project tree. The action has a red triangle next to it to indicate that it
is not configured.
12. Select
Rename
.
13. Enter
2tones_twice_chk
and press
Enter
.
14. Select
Configure
.
