code R30045.110en www.kseniasecurity.com
ed.06/2022
CONFIGURATION
The software configuration supplied by Ksenia is required.
Keypad programming instructions
Open <BUS peripherals -> User interfaces -> ergo-X> menu, if correctly installed, ergo-X will show its serial
number so it can be added in the system configuration by clicking on icon
and then wait for the
green icon
as positive feedback. To finish, fill in the optional fields and the numeric keys to run the
scenarios, save and apply configuration.
The contextual help describes whatever here is omitted. For all the details, please consult the “lares 4.0
programming manual”.
Key/mini-Tag programming instructions
Start recognition procedure of user’s key/mini-Tag by clicking “Enroll tags” icon from <System -> Users>
menu, then select “ergo-X” device and click on <START> button. Put the tag close to the ergo-X RFID area
and wait for a few seconds until you’ll see the number code displayed; at this point, select a name from the
Users list and click on STOP button to end the procedure. Repeat the procedure for each user with a key/
mini-Tag.
Led RGB programming instructions
In addition to the standard arming color (red, green, blue) of the RGB LED, to display the arming status of the
system, it is possible to recognize when one or more specific partitions associated with the keypad are
armed, thanks to a further customization of fuchsia, white and cyan led colors.
Open <BUS peripherals -> User interfaces -> ergo-X> menu, there are three fields, one for each led color
(
e.g.: “Partitions associated with Fuchsia color”
), program each field by choosing some partitions among
those to which the keypad belongs.
In our example
the keypad led will turn fuchsia when the armed partitions are exactly the ones customized
in this field.
If they do not match, the configuration of the "
Partition associated with White color
" field will be checked
and then the one of "
Partition associated with Cyan color
".
Again, if there is no match, then the led takes one of the standard colors (red, green, blue) according to the
arming status.
Scenarios/events programming instructions
To enable the user to arm the system by pressing <1> on ergo-X, for example, the installer must program:
the "Keypad" event with “Key 1” subtype and associated with the "Arming Mode" scenario.
From <System -> Scenarios> menu you can program any scenario and from <System -> Events> menu the
identities (keypad, users, zones, outputs, etc.) that generate the event to run the scenario.
