Commands.
Feed Hold is used to pause motion during file run and will leave the spindle on. Cycle start will resume motion and
continue file execution.
Retract is an optional feature, currently in development and not operational. Check in with MachMotion for more
information!
Cycle stop does a full cancel of the file, turns off the spindle and coolant, and puts the machine in idle.
Reset is used to clear alarms and set the machine back to default modals. These defaults can be changed in the
Initialization Codes sections of the default control configuration. Reset also does a full cycle stop and rewinds the
GCode file.
It is also the "Power" button. If the control is off, pressing Reset will power it on.
The Feedrate Override knob will modify Feedrate Override percent and will affect any G01 feed rate moves. The
feedrate percentage value is shown on the screen. If you are expecting motion and nothing is going, verify your
feedrate is not set to 0%.
The 4 Rapid Override buttons will set the Rapid Override percent and will affect any G00 rapid rate moves. The
percentages for each can be changed in the X15-[##] Operator Panel settings. You can access this from the Service
section, then Maintenance tab, then Interface Config button:
Spindle control buttons let you directly set the spindle forward, backwards, and stop. These are equivalent to calling
M3, M4, and M5. You can set a default spindle speed value that will be set any time the system is initialized (reset
pressed) by adding S### (where ### is the desired speed) in the Initialization Codes sections of the default control
configuration.
Coolant buttons allow you to toggle the mist and flood outputs. These are equivalent to calling M7, M8, and M9
3. Cycle Cancels
4. Feed Rate Overrides
5. Spindle Control
