3 - Command Set
DynaPro Mini| PIN Encryption Device | Programmer’s Manual (Commands)
Page 48 of 128 (
D99875629-43
)
Figure 3-6 - DynaPro Mini Manual Card Information Entry
If an error occurs, the device will terminate the command and report the error in ACKSTS of
. For a full list of error codes, see
Appendix C Status and Message Table, Table
If no error occurs, the device will send
Report 0x22 - Card Status Report
to the host. If the cardholder
or operator cancelled the request, or if the request timed out, byte 1 of
will contain the appropriate Operation Status code to indicate why the command did not
complete. Otherwise, if all of the card information was entered correctly, byte 1 = 0x00 (this command
completed OK), byte 2 = 0x00 (Card Status is OK), byte 3 = 0x03 (Card Type is manual), and the host
should send a request to get the card data (see
Command 0x0A - Request MSR Data
). The device will
respond with multiple instances of
Report 0x23 - Card Data Report
, followed by
Table 3-22 - Usage Table for Command 0x11
Bit
7
6
5
4
3
2
1
0
Byte 0
0x11
Byte 1
Wait Time in seconds, (1 - 255; 0 = 256 seconds)
Byte 2
0
0
0
0=Use PAN min
9, max 19
1=Use PAN min
14, max 21
1=Use
PAN in
PIN
block
creation
1=Use
Qwick
Codes
entry
Field Options:
0 = Acct,Date,CVC
1 = Acct,Date
2 = Acct,CVC
3 = Acct
Byte 3
Tones:
0 = No sound
1 = One beep
2 = Two beeps
The track data sent by the device for manually entered card data may be masked according to the device’s
configuration (the same as it is for credit/debit cards), but the data shown in the following examples is
unmasked just to show the detail. The account number or QwickCode is denoted by a string of 5s, the
expiration date (or PAN4) by 3s and the CVC by 4s. The location marked by ‘6’ indicates the field
options used when the data was collected; unused fields will be 0s. 0s below denote fixed-length filler.
Track 1 card type (‘B’ for credit/debit cards) is set to ‘M’ and the name is set to the string literal
“MANUAL ENTRY/”.
Track 1 data may be found in the instance of
Report 0x23 - Card Data Report
0x01. The device will format Track 1 card data as follows:
