Lab Manual for TCP 17051
Page | 13
Set Commands (Part 2 of 4)
Command
Default
D
e
s
cr
ip
ti
o
n
set ftp time
<
value
>
200
Sets the FTP timeout value, where <
value
> is a
decimal number that is five times the number of
seconds required.
set ftp user
<
string
>
roving
Sets the user name for accessing the FTP server.
set ip address
<
address
>
0.0.0.0
Sets the WiFly module’s IP address.
set ip backup
<
address
>
0.0.0.0
Sets a secondary host IP address.
set ip dhcp
<
value
>
1
Enables/disables DHCP mode.
set ip flags
<
mask
>
0x7
Sets the TCP/IP functions.
set ip gateway
<
address
>
0.0.0.0
Sets the gateway IP address.
set ip host
<
address
>
0.0.0.0
Sets the remote host’s IP address.
set ip localport
<
value
>
2000
Sets the local port number.
set ip netmask
<
address
>
255.255.255.0
Sets the network mask.
set ip protocol
<
flag
>
2
Sets the IP protocol.
set ip remote
<
value
>
2000
Sets the remote host port number.
set ip tcp-mode
<
mask
>
0x0
Controls the TCP connect timers, DNS
preferences, and remote configuration
options.
set opt average
<
value
>
5
Sets the number of RSSI samples used to calculate
the running RSSI average.
set opt deviceid
<
string
>
WiFly-
XXX
Sets the configurable device ID, where
XXX
is GSX
for the RN131 and EZX for the RN171.
set opt format
<
flag
>
0x00
Sets the HTTP client/web server information.
set opt jointmr
<
value
>
1000
Sets the join timer, which is the length of time (in
ms) the join function waits for the access point to
complete the association process.
set opt replace
<
char
>
$ (0x24)
Sets the replacement character you use to indicate
spaces in the SSID and pass phrases, where
<
char
> is a single character.
set opt password
<
string
>
“” (no password
required)
Sets the TCP connection password.
set opt signal
<
value
>
0
Configures the threshold level for the RSSI value in
infrastructure mode.
set q power
<
value
>
0
Automatically turns on the sensor power.
set q sensor
<
mask
>
0
Specifies which sensor pins to sample when
sending data using the UDP broadcast packet
or the HTTP auto sample function.
set sys autoconn
<
value
>
0
Sets the auto-connect timer in TCP mode.
set sys autosleep
<
value
>
0
Sets the auto-sleep timer in UDP mode.
set sys iofunc
<
mask
>
0x0
Sets the I/O port alternate functions.
set sys launch_string
<
string
> web_app
Sets the application to launch when GPIO9 is high
after powerup.
set sys mask
<
mask
>
0x20F0 (RN131)
0x21F0 (RN171)
Sets the I/O port direction.
set sys printlvl
<
value
>
0x1
Controls the debug print messages printed by the
WiFly module on the UART.
set sys output
<
mask
> <
mask
> None
Sets the output GPIO pins high or low. The
optional <
mask
> sets a subset of the pins.
