P61 firmware
© Nedap IDEAS, P.O. Box 103, NL-7140 AC GROENLO
Page 10 of 18
0265
Set 'time in event message' mode
Description:
Enables or disables the optional dummy timestamp characters in event
messages. This setting is stored in
EEPROM
and is only lost when a 'reset reader'
command is performed.
Syntax:
0101010265m
Reply:
-
Where:
m
0 = disabled (default). Dummy timestamp characters in event
messages will not be transmitted.
1 = enabled. Dummy timestamp characters in event messages are
transmitted.
0266
Request 'time in event message' mode
Syntax:
0101010266
Reply:
0101010266m
Where:
m
0 = disabled (default).
1 = enabled.
Notes:
See command message 0265.
0267
Set 'end-of-detection' mode
Description:
The end-of-detection event is a detection event with identification number 0. This
event is only send when the relay-hold time has expired. See timing diagram in
Figure 2. This setting is stored in
EEPROM
and is only lost when a 'reset reader'
command is performed.
Syntax:
0101010267m
Reply:
-
Where:
m
0 = end-of-detection event message disabled (default).
1 = end-of-detection event message enabled.
Notes:
See command message 0255.
0268
Request 'end-of-detection' mode
Syntax:
0101010268
Reply:
0101010268m
Where:
m
0 = end-of-detection event message disabled (default).
1 = end-of-detection event message enabled.
Notes:
See command message 0267.
