4
*********************************************************************************
COMMAND: *
ALLHLD<CR>
– Stops ramp action initiated by
*ALLV+<CR>
Or
*ALLV-<CR>
RESPONSE: #
ALLHLD-<CR>
This results in a HOLD of the level at time of command receipt.
*********************************************************************************
COMMAND: *
ALLMON<CR>
– ALL MUTE ON.
RESPONSE: #
ALLMON<CR>
*********************************************************************************
COMMAND: *
ALLMOFF<CR>
– ALL MUTE OFF.
RESPONSE: #
ALLMOFF<CR>
********************************************************************************
COMMAND: *
ZxxSRCp<CR>
– Switch zone xx to SOURCE p ( 1 to 6).
RESPONSE: Same response as for
*ZxxCONSR<CR>
*********************************************************************************
COMMAND: *
ZxxVOLyy<CR>
– Set volume of zone xx to level yy below max in dB from –0
to –78 dB (include lead 0 for all single-digit values).
RESPONSE: Same response as for
*ZxxCONSR<CR>
*********************************************************************************
COMMAND: *
<CR>
– STARTS zone xx volume ramp UP at the rate of +10 dB per
second in +1 dB steps. (This is the same as holding VOLUME UP key on a KEYPAD for 1
second).
RESPONSE: Same response as for
*ZxxCONSR<CR>, updated 10 times per second.
*********************************************************************************
COMMAND: *
ZxxVOL-<CR>
– STARTS zone xx volume ramp DOWN at the rate of -10 dB
per second in -1 dB steps. (This is the same as holding VOLUME UP key on a KEYPAD for 1
second).
RESPONSE:
Same response as for *ZxxCONSR<CR>, updated 10 times per second.
*********************************************************************************
COMMAND: *
ZxxVHLD<CR>
– STOPS zone xx volume ramp initiated by
*<CR>
or
*ZxxVOL-<CR>
commands. This results in a HOLD of the level at time of command receipt.
RESPONSE: #
ZxxVHLD<CR>
*********************************************************************************
COMMAND: *
ZxxMTON<CR>
– zone xx MUTE ON (mutes currently connected source)
RESPONSE:
Same response as for *ZxxCONSR<CR>
*********************************************************************************
COMMAND: *
ZxxMTOFF<CR>
– zone xx MUTE OFF (returns zone output to currently
connected source at previous volume setting).
RESPONSE:
Same response as for *ZxxCONSR<CR>
*********************************************************************************
COMMAND: *
ZxxBASSyyy<CR>
– zone xx BASS EQ with yyy = EQ level, dB, –12 to
+0 (flat) to +12 in 2 dB increments. USE LEAD “0” IN TENS PLACE FOR VALUE LESS THAN
10.
RESPONSE:
Same response as for *ZxxSETSR<CR>
