RAK RAK2247, Quick Start Manual

Documentation Center

4. Next, you need to insert the name you got in Step 3 for your interface in the following files:

rak_common_for_gateway/lora/set_eui.sh
rak_common_for_gateway/lora/update_gwid.sh

Then, replace the following line:

With the line,

Again, the values are just an example. Remember to do this for all 3 files in step 4.

5. Change the 

global_conf.json

 that will be copied during installation by replacing the

global_conf.eu_863_870.json

 in the end of the (install.sh file)

[https://github.com/RAKWireless/rak_common_for_gateway/blob/master/lora/rak2247_usb/install.sh] to one of
those inside 

/global_conf

 or a custom one. (EU868 is the default)

📝

 NOTE:

You may also comment on the line below so the TTN address doesn't get replaced by localhost.

6. If you are using the RAK2247 in a board that has a different pinout than the RAK2247 Pi Hat, replace the

SX1301_RESET_BCM_PIN

 in the 

rak_common_for_gateway/lora/start.sh

 to the corresponding RESET pin.

📝

 NOTE:

If you want to have your Gateway_ID automatically update when running your package forwarder,
uncomment and change the line 

#./update_gwid.sh ./local_conf.json

 in the same file (start.sh) to

./update_gwid.sh ./global_conf.json

.

7. Add the following lines of code at the end of “install.sh” file: ( In addition to inserting the name of the interface

from the previous step)

cd

 rak_common_for_gateway/lora/rak2247_usb 

GATEWAY_EUI_NIC=”eth0” 

GATEWAY_EUI_NIC=”wlx6045bdf0cf64h0” 

cp

 global_conf/global_conf.eu_863_870.json 

$INSTALL_DIR

/packet_forwarder/lora_pkt_fwd/global_conf

# sed -i "s/^.*server_address.*$/\t\"server_address\": \"127.0.0.1\",/" $INSTALL_DIR/packet_forwa

# Reset iC880a PIN

SX1301_RESET_BCM_PIN

=<

YOUR_RESET_PIN_HERE

>

sh

sh

sh

sh