Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
959
User Manual 1178.8520.02 ─ 01
14.8.2
Configuring the Trace Display and Retrieving Trace Data
The commands required to work with traces are described here.
Commands required to export traces (and other result data) are described in
ter 14.9.5, "Storing Measurement Results"
................................................................................ 959
.................................................................................... 965
..................................................................................... 972
.......................................................................................974
Formats for Returned Values: ASCII Format and Binary Format
Importing and Exporting Traces
............................................................................ 977
Programming Example: Configuring a Spectrogram
.............................................979
14.8.2.1
Configuring Standard Traces
Useful commands for trace configuration described elsewhere
●
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:Y:SPACing
●
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]
Remote commands exclusive to trace configuration
DISPlay[:WINDow<n>]:TRACe<t>:MODE
.........................................................................959
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:MODE:HCONtinuous
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<undef>:PRESet
.....................................961
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>[:STATe]
............................................ 961
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:SMOothing:APERture
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:SMOothing[:STATe]
........................... 962
........................................................................................ 963
...................................................................................963
.......................................................................................... 963
[SENSe:][WINDow<n>:]DETector<t>[:FUNCtion]
............................................................... 964
[SENSe:][WINDow<n>:]DETector<t>[:FUNCtion]:AUTO
..................................................... 964
DISPlay[:WINDow<n>]:TRACe<t>:MODE
<Mode>
This command selects the trace mode. If necessary, the selected trace is also activa-
ted.
In case of max hold, min hold or average trace mode, you can set the number of single
measurements with
. Note that synchronization to the end of
the measurement is possible only in single sweep mode.
Suffix:
<n>
.
Analyzing Measurements (Basics)