Command reference
R&S
®
ZNB/ZNBT
946
User Manual 1173.9163.02 ─ 62
CALCulate<Chn>:MARKer<Mk>:DELTa[:STATe]
<Boolean>
Switches the delta mode for marker
<Mk>
on trace no.
<Chn>
on or off. The marker
must be created before using
CALCulate<Chn>:MARKer<Mk>[:STATe]
ON
. If the
active trace contains no reference marker, the command also creates a reference
marker.
Suffix:
<Chn>
.
Channel number used to identify the active trace
<Mk>
Marker number.
Parameters:
<Boolean>
ON | OFF - Enables or disables the delta mode.
*RST:
OFF
Example:
Suppose that the active recall set contains an active trace no. 1.
CALC:MARK ON
Create marker no. 1 and set it to the center of the sweep range.
CALC:MARK:DELT ON
Create a reference marker at the center of the sweep range and
set marker 1 to delta mode.
Manual operation:
See
CALCulate<Chn>:MARKer<Mk>:EXCursion
<Value>
CALCulate<Chn>:MARKer<Mk>:REFerence:EXCursion
<TargetSearchVal>
Defines a marker-specific minimum excursion value for peak searches.
Use
CALCulate<Chn>:MARKer<Mk>:EXCursion:STATe
or
MARKer<Mk>:REFerence:EXCursion:STATe
to activate it.
Suffix:
<Chn>
.
Channel number used to identify the active trace
<Mk>
Marker number (ignored for reference markers)
Parameters:
<Value>
Minimum peak excursion
The unit is derived from the active trace format and cannot be
modified. Changing the trace format resets the excursion to a
format-specific default value.
Manual operation:
See
CALCulate<Chn>:MARKer<Mk>:EXCursion:STATe
<Boolean>
CALCulate<Chn>:MARKer<Mk>:REFerence:EXCursion:STATe
<Boolean>
Activates or deactivates the marker-specific minimum excursion for peak searches.
Use
CALCulate<Chn>:MARKer<Mk>:EXCursion
or
MARKer<Mk>:REFerence:EXCursion
to set the minimum peak excursion.
SCPI command reference
