RDL-2000
User Manual
70-00143-01-01a
Proprietary Redline Communications © 2010
Page 47 of 50 September 24, 2010
Table 9: CLI - Command Summary
off
- Disable RSSI.
on
- Enable RSSI.
Example: Read current RSSI value:
[192.168.25.2] >>:rssi
rssi -59 [dBm]
sweep <start | stop> <all | channel(s)>
Perform an RF scan for interference. No user data is transmitted over the wireless link
while this test is running. A reboot is required to restore normal operation.
Start
: Begin scanning the selected channels. The wireless link is offline.
Stop
: Stop scanning channels. Reboot and resume normal operation.
all
: Scan all available channels
channel(s)
: Enter one or more RF channel frequencies to be scanned.
Example: Scan all enabled channels:
[192.168.25.2] >>:sweep start all
RF Analyzer: CH = #1 rssi = -77 dBm
RF Analyzer: CH = #2 rssi = -78 dBm
RF Analyzer: CH = #3 rssi = -48 dBm
switchbank [soft | pld | both]
Switch between the active and inactive banks of the software. A system reboot is
required to activate the selected software version.
soft
or
[blank]
: Switch the software load.
pld
: Switch the firmware load (e.g., bootloader).
both
: Switch the software and firmware load.
Example: Switch to the alternate software load and reboot:
[192.168.25.2] >>:
switchbank
update
Activate and permanently save (non volatile RAM) all changes to the system
parameters. Saving changes to some parameters will automatically reset the RDL-
2000.
Example: Activate and save all parameter changes:
[192.168.25.2] >>:
update
