Remote-Control Commands
IEEE 802.11 (a/b/g)
54
Operating Manual 1171.5283.12 ─ 18
USER
(OFDM only)The scrambler is activated. The initialization value
of the scrambler is set to a fixed value that is entered at "Scram-
bler Init (hex)". This value is then identical in each generated
frame.
ON
(CCK | PBCC only)The scrambler is activated.
PONLy
(CCK | PBCC only)The scrambler is activated. Only the data of
the preamble is scrambled.
*RST:
RAND (OFDM), ON (CCK/PBCC)
Example:
BB:WLAN:SCR OFF
the scrambler is deactivated.
Manual operation:
See
[:SOURce<hw>]:BB:WLAN:SCRambler:PATTern
<Pattern>, <BitCount>
The command enters the initialization value for scrambling mode User. This value is
then identical in each generated frame. The command is only available for physical
layer mode OFDM (
SOURce:BB:WLAN:MODE OFDM
).
Parameters:
<Pattern>
numeric
Range:
#H0,0 to #HFF,8
*RST:
#H0,0
<BitCount>
integer
Range:
1 to 8
*RST:
1
Example:
BB:WLAN:SCR USER
the scrambler is activated.
BB:WLAN:SCR:PATT #H3F,8
the initialization value is set.
Manual operation:
See
" Scrambler Init (hex) (OFDM) "
[:SOURce<hw>]:BB:WLAN:SERVice[:PATTern]
<Pattern>, <BitCount>
The command enters the value for service field The command is only available for
physical layer mode OFDM (
SOURce:BB:WLAN:MODE OFDM
).
Parameters:
<Pattern>
numeric
Range:
#H0,0 to #HFF,8
*RST:
#H0,0
General Commands