17
users Commands
This section describes commands used to create and manage user accounts on the network. These
commands are found within the users context of the CLI.
All CLI commands cache changes. For this reason, sometimes when you make a change in a particular
context, the change may not be visible immediately. If this happens, you must exit and re-enter the
context in order to ensure that the database is synchronized with the latest change.
The following commands are available in the users context:
•
on page 232
•
on page 233
id
Use the
id
command to create user or administrator accounts on the system. In conjunction with the
id
command, you must specify and confirm a password for the account. The password must be 8–24
alphanumeric characters long.
id userid admin|guestportal|readonly
Parameters
userid
Specifies a name for the account
admin
Sets account type to administrator
guestportal
Sets account type to guestportal administrator. A guest administrator user created
using the guestportal user type can login to the system only via the GUI.
readonly
Sets account type to readonly
Examples
The following example creates the read-only user account “abby” on the system:
WLC.siemens.com
:users# id abby readonly
Please input password:
Please confirm password:
Successfully created user abby.
SCALANCE WLC711 CLI Reference Guide
232
Summary of Contents for scalance WLC711
Page 1: ...SCALANCE WLC711 CLI Reference Guide Release V9 21 14 C79000 G8976 C261 07 Published July 2015 ...
Page 21: ...dns 2 192 1 2 3 dns 3 192 1 3 3 Common Commands show SCALANCE WLC711 CLI Reference Guide 21 ...
Page 376: ...Example topology Commands vlanid SCALANCE WLC711 CLI Reference Guide 376 ...