Examples
The following example enables the Chargeable-User-Identity attribute in Access-Request message:
WLC.siemens.com
:wlans:Lab184-AAA:auth# include-cui-type enable
interim
Use the
interim
command to configure the RADIUS accounting server interim accounting interval.
The
interim
command is accessible from the wlans:<WLAN-service-name>:auth context of the CLI.
interim interim-interval-value
Parameters
interim-interval-value
Specify an integer value in minutes for the interim interval. The default
value is 30 minutes.
Usage
The
interim
command is not available when the authentication mode is guestportal. When the
authentication mode is disabled, MAC must be enabled for this command to be available. For
authentication
mode
command information, see
on page 302. For
mac
command information, see
on page 299.
Example
The following example sets the interim value to 40 minutes:
WLC.siemens.com
:wlans:test:auth# interim 40
mac
Use the
mac
command to enable or disable MAC based authentication. The
mac
command is accessible
from the wlan:<WLAN-service-name>:auth context of the CLI.
mac enable | disable
Parameters
enable
|
disable
Specifies to enable or disable MAC based authentication
Usage
The
mac
command is not available in the guest splash and guest portal authentication modes. For more
information, see
on page 302.
Example
The following example enables MAC authentication for the test WLANS:
WLC.siemens.com
:wlans:test:auth# mac enable
WLC.siemens.com
:wlans:test:auth# show mac
MAC based authorization: enable
wlans Commands
interim
SCALANCE WLC711 CLI Reference Guide
299
Summary of Contents for scalance WLC711
Page 1: ...SCALANCE WLC711 CLI Reference Guide Release V9 21 14 C79000 G8976 C261 07 Published July 2015 ...
Page 21: ...dns 2 192 1 2 3 dns 3 192 1 3 3 Common Commands show SCALANCE WLC711 CLI Reference Guide 21 ...
Page 376: ...Example topology Commands vlanid SCALANCE WLC711 CLI Reference Guide 376 ...