Response for Logical Level Input Options:
Set output messages for input pin states. The messages will be transmitted or output on serial when the input pin
state changes.
Input Pins: set pins whose states will be monitored.
Capcode: a different capcode can be assigned per input.
Debounce Time: time that contact must be triggered for before the alarm signal is generated.
Retrigger Delay: a period during which a new alarm will not be triggered again after the first trigger if multiple
triggers occur. This only applies to non normal alarm trigger. Zero will disable this function.
Repeat Interval: this is the time interval after which if the state of contact has not reverted to its normal state then
the message will be retransmitted and will continue to be retransmitted on this interval until the alarm reverts to
normal. This only applies to non normal alarm trigger. Zero will disable this function.
State High Message: a message will be transmitted or output on the serial when the pin state high occurs. If no
message is entered then no alarm transmission will occur on the change to high state.
State Low Message: a message will be transmitted or output on the serial when the pin state low occurs. If no
message is entered then no alarm transmission will occur on the change to low state.
Normal High: Set normal or start pin state as high. If not selected then the normal state is low.