KLIC-DA LT
Technical Support:
http://zennioenglish.zendesk.com
14
3.1.1.2
CLIMATE
No additional parameter configuration is required for this function.
If enabled, the following communication objects will be available:
[Climate] On/Off
: one-bit object that will make KLIC-DA LT turn on the
climate control function when a “1” is received from the KNX bus, while one
“0” will make it turn the climate control function off.
[Climate] Operation Mode
: one-bit object that will make KLIC-DA LT switch
the current operation mode of the climate system to
Cooling
(value “0”) or to
Heating
(value “1”).
Note
:
although available from the main user control, the “automatic” mode
cannot be activated from KLIC-DA LT. If a mode switch order is received from
the KNX bus, KLIC-DA LT will ensure that the automatic mode gets
deactivated in the climate system.
[Climate] Temperature
: two-byte object that sets the desired setpoint
temperature for the climate system. In case the value received through this
object exceeds the allowed setpoint range, the Altherma LT system itself will
truncate it to the minimum or maximum values, notifying afterwards the
effective change to KLIC-DA LT.
[Climate] On/Off (Status)
: one-bit object that reflects whether the climate
system is currently on (value “1”) or off (value “0”).
[Climate] Operation Mode (Status)
: one-bit object that reflects the currently
active operation mode (“0” = Cooling; “1” = Heating), no matter if the
automatic mode has been set or not from the main user control.
[Climate] Temperature (Status)
: two-byte object that reflects the current
setpoint temperature of the climate system.
[Climate] Operating (Status)
: one-bit object that shows whether the climate
system is in operation (value “1”) or not (value “0”).
Whenever the Altherma LT system notifies a status change, the corresponding
status
object
will be automatically sent by KLIC-DA LT to the KNX bus.
