Programming
8
AXP-CCS/AXM-CCS Softwire Camera Centers
Pushbutton LEDs
Each LED in the camera center's pushbuttons is assigned with feedback. This is a programming
example:
[device number, LED button number] = [RELAY, 1]
The LED follows the status of device RELAY, channel, or relay number 1.
LED illumination level commands
The table below lists the commands to set the LED illumination levels on the panel's pushbuttons.
’DIM <Dim mode 0 - 7>’
You may enter the configuration mode or toggle these functions as often required.
Levels
Levels are the values that are related to the analog input or output on the AXP-AI8 device in the
AXP-CCS. The following table lists the levels.
LED Illumination Level Commands
Mode Description
0
100% duty cycle (default); brightest setting.
1
50% duty cycle
2
25% duty cycle
3
12.5% duty cycle
4
Not used
5
4.5 duty cycle
6
3% duty cycle
7
1.5% duty cycle; dimmest setting.
Levels
Level
Description
1
Pan
2
Tilt
3
Zoom
4
Focus
5
Pan/Tilt speed
6
Zoom/Focus speed
Summary of Contents for AXM-CCS
Page 1: ...instruction manual Camera Control Systems AXP CCS AXM CCS Softwire Camera Centers ...
Page 4: ...ii AXP CCS AXM CCS Softwire Camera Centers Table of Contents ...
Page 6: ...Product Information 2 AXP CCS AXM CCS Softwire Camera Centers ...
Page 13: ...Programming 9 AXP CCS AXM CCS Softwire Camera Centers ...
