Chapter 4 Zone Configuration
Zone Remote Guard List
4-10
Cisco Traffic Anomaly Detector User Guide
OL-6109-01
This section contains the following procedures:
•
Adding a Guard to the Zone Remote Guard List
•
Removing a Guard from the Zone Remote Guard List
•
Interactive Recommendations Mode
Adding a Guard to the Zone Remote Guard List
The user may add one or more Guards to the zone remote Guard list.
To add a remote Guard or Guards to the zone remote Guard list perform the
following:
1.
From the Zone command group level type the following:
admin@DETECTOR-conf-zone-<
zone-name
>#
remote-guard
<
remote-guard-address
> [<
description
>]
Where:
–
remote-guard-address
—The desired remote Guard IP address.
–
description
—(Optional) The remote Guard description (a maximum of
63 characters).
2.
Choose
ENTER
.
3.
Repeat steps one and two as many times as required.
Below is an example of the
remote-guard
command implementation:
admin@DETECTOR-conf-zone-scannet#
remote-guard 192.168.100.33
admin@DETECTOR-conf-zone-scannet#
Removing a Guard from the Zone Remote Guard List
The user may remove a Guard from the remote Guard list.
To remove a Guard from the remote Guard list perform the following:
1.
From the Zone command group level type the following:
admin@DETECTOR-conf-zone-<
zone-name
>#
no remote-guard
<
remote-guard-address
>