Ethernet Configuration Commands
Page 94
port storm-control include-multicast
The
port storm-control include-multicast
Interface Configuration (Ethernet) mode command counts multicast
packets in broadcast storm control. To disable counting multicast packets, use the
no
form of this command.
Syntax
port storm-control include-multicast [unknown-unicast]
no port storm-control include-multicast
Parameters
•
unknown-unicast
—
Specifies also counting unknown unicast packets.
Default Configuration
Multicast packets are not counted.
Command Modes
Interface Configuration (Ethernet) mode
User Guidelines
To control multicast storms, use the
port storm-control broadcast enable
and
port storm-control broadcast
rate
commands.
Example
The following example enables counting broadcast and multicast packets on Ethernet port 3.
Console(config)#
interface ethernet
3
Console(config-if)#
port storm-control include-multicast
console(config-if)#
port storm-control include-multicast unknown-unicast
Summary of Contents for DES-3010FA
