xStack
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
460
To config PoE port:
DGS-3426P:admin# config poe ports 1-4 state enable priority critical power_limit class_1
Command: config poe ports 1-4 state enable priority critical power_limit class_1
Power limit has been set to 4000mW (Class 1 PD upper power limit 3.84W + power loss on
cable).
Success.
DGS-3450:admin# config poe ports 5 state enable priority critical power_limit user_define
1000
Command: config poe ports 5 state enable priority critical power_limit user_define 1000
Power limit has been set to 1000mW.
Success.
DGS-3426P:admin#
show poe system
Purpose
Used to display the setting and actual values of the whole PoE system.
Syntax
show poe system {units <unitlist>}
Description
Display the setting and actual values of the whole PoE system.
Parameters
units
- Specified units that will be displayed.
If no parameter specified, the system will display the status of all supported poe units in the
systems.
Restrictions
None.
Example usage:
To display PoE system:
DGS-3426P:admin# show poe system units 1
Command: show poe system units 1
Unit 1 PoE System Information
---------------------------------------------------
Power Limit : 250(watts)
Power Consumption : 0(watts)
Power Remained : 250(watts)
Power Disconnection Method : Deny Low Priority Port
Detection Legacy PD : Disabled
If Power Disconnection Method is set to deny next port, then the system cannot utilize
its maximum power capacity. The maximum unused watt is 19W.
DGS-3426P:admin#
show poe ports
Purpose
Used to display the setting and actual values of PoE port.
Syntax
show poe ports {<portlist>}
Description
Display the setting and actual values of PoE port.
Parameters
portlist
- Specified a list of ports to be displayed.
