Epsilon-12G2 User Manual Revision A.02
www.diamondsystems.com
Page 12
Display the IP address to confirm:
# show ip interface brief
Vlan Address Method Status
---- -------------------- -------- ------
1 192.0.2.1 Manual UP
#
7.1.2 General Command Groups
The following groups of general commands are available in the command line interface (CLI).
# ?
clear Reset functions
configure Enter configuration mode
copy Copy from source to destination
debug Debugging functions
delete Delete one file in flash: file system
dir Directory of all files in flash: file system
disable Turn off privileged commands
do To run exec commands in config mode
dot1x IEEE Standard for port-based Network Access Control
enable Turn on privileged commands
exit Exit from EXEC mode
firmware Firmware upgrade/swap
help Description of the interactive help system
ip IPv4 commands
logout Exit from EXEC mode
more Display file
no Negate a command or set its defaults
ping Send ICMP echo messages
reload Reload system.
send Send a message to other tty lines
show Show running system information
terminal Set terminal line parameters
#
You may get help by pressing the
?
key or entering
help
. The help info depends on the context:
At top level, a list of command groups is displayed.
At group level, a list of the command syntaxes for the current group is displayed.
If the help command is issued for a specific command, the command syntax and a description of the
command are shown
7.1.3 IP Commands
(config)# ip http secure-redirect
(config)# ip http secure-server
(config)# ip igmp snooping
(config)# ip igmp snooping vlan <v_vlan_list>
(config)# ip igmp unknown-flooding
(config)# ip route <v_ipv4_addr> <v_ipv4_netmask> <v_ipv4_gw>
(config)# ip dhcp retry interface vlan <vlan_id>
(config)# no ip http secure-redirect
(config)# no ip http secure-server
(config)# no ip igmp snooping
(config)# no ip igmp snooping vlan [ <v_vlan_list> ]
