ESR Series Routers Operation Manual
53
To check the routing table, use the following command:
esr#
show ip route
7.11
MLPP configuration
Multilink PPP (MLPPP) is an aggregated channel that encompasses methods of traffic transition via
multiple physical channels while having a single logical connection. This option allows to enhance
bandwidth and enables load balancing.
Fig. 7.9
—
Network structure
Objective: Configure MLPPP connection to the opposite side with IP address 10.77.0.1/24 via MXE
device.
Solution:
Switch gigabitethernet 1/0/10 interface into E1 operation mode:
esr#
configure
esr(config)#
interface gigabitethernet 1/0/10
esr(config-if-gi)#
description "*** MXE ***"
esr(config-if-gi)#
switchport mode e1
esr(config-if-gi)#
switchport e1 slot 0
esr(config-if-gi)#
exit
Enable interface e1 1/0/1, interface e1 1/0/4 into MLPPP 3 aggregation group:
esr(config)#
interface e1 1/0/1
esr(config-e1)#
ppp multilink
esr(config-e1)#
ppp multilink-group 3
esr(config-e1)#
exit
esr(config)#
interface e1 1/0/4
esr(config-
е
1)#
ppp multilink
esr(config-
е
1)#
ppp multilink-group 3
esr(config-
е
1)#
exit
Configure MLPPP 3:
esr(config)#
interface multilink 3
esr(config-multilink)#
ip address 10.77.0.1/24
esr(config-multilink)#
security-zone trusted
esr(config-multilink)#
exit
esr(config)#
exit
Configuration changes will take effect when the following commands are executed:
esr#
commit
Configuration has been successfully committed
esr#
confirm
Configuration has been successfully confirmed
esr#