32
C
HAPTER
3: L
OGGING
ONTO
MSR S
ERIES
R
OUTERS
# Enable Telnet server.
[H3C]telnet server enable
% Start Telnet server
# Configure the IP address of the interface that connects to the Internet. You can
change this IP address to what is in use.
[H3C]interface ethernet0/0
[H3C-ethernet0/0]ip address 192.168.0.1 24
# Enter vty interface view.
[H3C]user-interface vty 0
# Set login password to 123456 and priority to 2.
[H3C-ui-vty0]set authentication password cipher 123456
[H3C-ui-vty0]user privilege level 2
Logging onto the router
Ensure the reachability between the terminal and the router, and then you can log
onto the router remotely.
**************************************************************************
* All rights reserved (2004-2006)
*
* Without the owner’s prior written consent,
*
* no decompiling or reverse-switch fabricering shall be allowed.
*
**************************************************************************
Login authentication
Password:
<H3C> system-view
[H3C]
Enter password 123456 when the system prompts entering the password. You can
perform operations on the router after entering the correct password.
Introduction to User
Interface
User Interface
Supported on MSR
Series Routers
Table 13
Introduction to user interface
User interface Corresponding user Port
type
Description
Console user
interface
User logging through
Console port
Console port
There is only one
Console user for each
router
TTY user
interface
User logging through
TTY interface
TTY interface
Different products
support different
numbers of users. Use
the
display
user-interface
command to check it.
Summary of Contents for MSR 20-20
Page 4: ......
Page 8: ...8 CHAPTER 1 INTRODUCTION...
Page 28: ...28 CHAPTER 2 FEATURE DESCRIPTION...
Page 34: ...34 CHAPTER 3 LOGGING ONTO MSR SERIES ROUTERS...
