4.9.2. Autodialer configuration commands
4.9.2.1. Emergency numbers programming
The text message used to set up
to four emergency phone numbers
for the autodialer is as follows:
Response:
[“OK”,“OK”,“OK”,“OK”]
4.9.2.2. Elevator car top and pit emergency phone numbers programming
The following SMS must be sent to programme rescue numbers for the car top and pit:
12345,S:$sos0:“sos_phone_number_1”,S:$sos1:“sos_phone_number_2”
Response:
[“OK”,“OK”]
4.9.2.3. Periodical test programming
GSR is able to run the periodical test through two different channels:
using data
sending IP packets or
using the
voice channel
with a phone call. The device can store up to 4 different test destinations. It
works with both URL addresses and phone numbers, users can set
up to 4 memory positions
. GSR
will do the test starting with the one that is in first position, if the process is successful it will not repeat it
until the periodical test period is reached. In case the first test position is not successful it will skip to the
next one and if this one is not successful either it will try with the one after it until verifies the test is OK
or reaching the fourth and last position. Both phone numbers and URL addresses are stored in
memories
test0, test1, test2 y test3
.
Programming these memories can be done with the following SMS:
Response:
[“OK”,“OK”,“OK”,“OK”]
Nayar Systems
GSR - 1_en
Page 28 of 35
