Chapter 1
Introduction
This Hardware User’s Guide for the MIMXRT1010 Evaluation Kit (EVK) is based on the NXP Semiconductor i.MX RT1010
Processor. This board is fully supported by NXP Semiconductor. The guide includes system setup and debugging, and provides
detailed information on the overall design and usage of the EVK board from a hardware systems perspective.
1.1 Board overview
This EVK board is a platform designed to showcase the most commonly used features of the i.MX RT1010 Processor in a small,
low cost package. The MIMXRT1010 EVK board is an entry level development board, which gives the developer the option of
becoming familiar with the processor before investing a large amount or resources in more specific designs.
Features of the MIMXRT1010 EVK board are shown in
Board features
Table 1. Board features
Processor
NXP Processor
MIMXRT1011
DCDC
MPS
MP2144GJ
LDO
UNION
UM1750S-00
Mass Storage
128 Mbit Quad SPI Flash
4 Mbit LPSPI FLASH (DNP)
USB
USB 2.0 OTG Connector
Audio Connector
3.5 mm Audio Stereo Headphone Jack
Board-Mounted Microphone
Left & Right Speaker Out Connectors
SPDIF Interface (DNP)
Debug Connector
JTAG 10-pin Connector (SWD by default)
OpenSDA with DAP-Link
Sensor
FXOS8700CQ: 6-Axis Ecompass (3-Axis Mag, 3-Axis Accel) (DNP)
User Interface Button
ON/OFF, POR Reset, POWER Reset, USER Button
Led Indicator
Power Status, Reset, OpenSDA, USER LED
Expansion Port
Arduino Interface
PCB
3.346-inch x 3.543-inch (8.5cm x 9cm), 2-layer board
Board overview
MIMXRT1010 EVK Board Hardware User’s Guide, Rev. 0, 30/07/2019
NXP Semiconductors
3
