Reference Manual Rev 1.13
004R-646-113
Page 133
L1
L2
L3
L4
Item
CLR.ASK
Print: Confirm clear
AUTO
Print: Automatic
IL.TYPE
Print: Interlock type
I.LOCK
Print: Interlock
MODE
Units: Mode
UNIT
Units: Alternative unit
U.STR
Units: Alternative unit string
AUT.OUT
Single: Auto Output to use
BLANK
Blank: Blanking function
FUNC
Remote Key: Function to trigger
CLR.TOT
Report print clear totals
SER.NET
ADDR
Network address
NUM
Number of networks
STRT.CH
Start char for Lua buffer protocol
END.CH.1
End char for Lua buffer protocol
END.CH.2
End char for Lua buffer protocol
NET.1 –
NET.n
TYPE
Protocol type
SERIAL
Serial port
RESP
Respond to simple commands
SOURCE
Barcode protocol source
SER.AUT
NUM
Number of Serial outputs
AUTO.1 –
AUTO.n
TYPE
Frequency
SERIAL
Serial port
FORMAT
Format
SOURCE
Weight type
EV.AUTO
Custom format string
NUM
Number of printouts
HEADER
Header
FOOTER
Footer
PAGE
WIDTH
Page width
HEIGHT
Page Height
PG.END
Page End String
SPACE
TOP
Blank lines at the top
LEFT
Blank characters on the left
BOTTOM
Blank lines at the bottom
PRINT.1 –
PRINT.n
TYPE
Printout type
FORMAT
Format
SERIAL
Serial port
NAME
Name
CUSTOM
PRN.KEY
Custom string for docket printout (K404)
EV.D.NEW
Custom string for new docket
EV.D.END
Custom string for end of docket (normal mode)
EV.WI
Custom string for weigh in
EV.WO.1
Custom string for weigh out with PT
EV.WO.2
Custom string for weigh out with first weight
EV.D.WO
Custom string for end of docket when weighing out
EV.AXLE
Custom string for each axle (K405 and K422)
ABORT
Custom string if weighing aborted (K405 and K422)
EV.GRP
Custom string for each axle group (K422)
REP.ST
Custom string for start of report
REP.PR
Custom string for each product in a report
REP.END
Custom string for end of report
SETP
NUM
Number of Setpoints
SETP1 ..
SETP8
(K422)
SETP16
(K404/K405)
TYPE
Type of setpoint
OUTPUT
Output to use
LOGIC
Active High or Active Low logic control
ALARM
Setpoint Alarm
SOURCE
Weight type
HYS
Hysteresis
MASK
Logic setpoint mask
DELAY
Pulse delay
ON
Pulse duration
TIMING
Setpoint output timing
RESET
IO to reset setpoint
PLS.NUM
No. of output pulses when setpoint is triggered
RST.LGC
Reset input is active when HIGH or LOW
DLY.ON
Logic setpoint delay on