Configuring / Programming
9.5 Configure BACnet client
PN/BACnet LINK
Operating Instructions, 10/2017, A5E39895543-AA
67
Configuring monitoring
You set client-specific monitoring parameters on this page.
1.
You enable the monitoring of configured BACnet devices by setting a check mark.
2.
Specify the desired monitoring interval. See section Monitoring functions (Page 42).
Figure 9-9
Monitoring
The monitoring interval set here applies globally for all BACnet devices, for which
communication relationships are configured. If a device is not reached in the configured
monitoring interval, the PN/BACnet LINK issues a corresponding diagnostic. This diagnostic
result is cleared as soon as the device is accessible again (see section Monitoring functions
(Page 42))
Setting the priority for write operations
On this page, you define the priority with which the BACnet client writes output objects
(binary output or analog output) in referenced BACnet devices.
Figure 9-10 Priority for write operations
The priority set here applies globally to all configured write operations on objects in other
BACnet devices. The highest priority is "1". The lowest priority is "16".
Summary of Contents for SIMATIC PN/BACnet LINK
Page 1: ......
