-22-
(4)IC Card Communication (2K bit card)
This command sends specific IC commands to IC card. The commands depend
on IC card specification.
The command data line has to be the 6 bytes data line, with Byte-1 through
Byte-3 of IC card commands characterized.
To send read command, please put the number of data bytes in to Byte-3.
When failing to write data (such as writing the same data), status returns an error.
Refer to the IC card specification for detailed information
STX
85h
Command data
ETX
BCC
Command format
STX
85h
Status
Data
ETX
BCC
Response format
(5) IC Card Block Write (8K bit card)
This command writes all data on the data line at once.
Address 1 shows the top of write start position. Address 2 shows the bottom of
write start position.
Data is written from the write start position with the "Write / Erase without
Protect Bit" command.
The maximum data amount which is wiritten at one time is 255 bytes.
After writing, the data is verified.
(6) IC Card Block Write (2K bit card)
This command writes all data on the data line at once.
Data is written from the write start position with "Update Main Memory" com-
mand.
After writing, the data is verified.
STX
87h
Address
Data line
ETX
BCC
Command format
STX
87h
Status
ETX
BCC
Response format
STX
86h
Address 1
Address 2
Data line
ETX
BCC
Command format
STX
86h
Status
ETX
BCC
Response format
Summary of Contents for MCM300 SERIES
