CHAPTER 3: Configuration Mode Commands
88
WatchGuard Vclass 5.1
password contains the pound (#) character, it
needs to be placed in double quotes.
[<-dial_on_demand|-always_on> <num>
This allows you to set PPPoE to Dial-on-Demand or
Always On mode. The function of
<num>
following
this option differs in each mode. For Dial-on-
Demand mode, this number indicates the inactivity
timeout interval in minutes (default is 20 minutes).
For Always On mode, this number indicates the
auto-reconnect interval in seconds (default is 60
seconds).
[-unnumbered_pppoe <a.b.c.d>|disable]]
This option allows you to use unnumbered PPPoE.
For more information on unnumbered links, see
RFC 1812 section 2.2.7
.
[backup [ip <a.b.c.d> mask <a.b.c.d>
gateway <a.b.c.d> ] | [dhcp [host_id] ]
| [pppoe -user "name" -password
"password"]
[unnumbered_pppoe <a.b.c.d>|disable]
[disable]
[switch_to_backup]
This allows you to enable a Backup WAN
connection for Interface 1, for systems that have
unreliable ISPs or network providers. You can
configure the failover connection as static, by
typing the IP address, netmask, and gateway. You
can configure the failover connection as DHCP
using the
[dhcp ["host_id"]]
syntax. You can
configure the interface as PPPoE (always on) using
the
[pppoe -user "name" -password
"password"]
syntax. You can configure the
backup WAN connection as unnumbered PPPoE
using the syntax
[unnumbered_pppoe
<a.b.c.d>|disable]
.
You can disable the backup connection by using the
option
[disable]
.
