54
Control.ini
8.1
Structure of the Control.ini file
It must always start with the definition of the input event. As
a start condition either an "
", "
"
or "
" can be used.
ATTENTION!
The limit is one trigger event per line.
Only variable conditions can be combined in one
line. If you need a combination of several trigger
events you have to do this via variables.
8.1.1 !i: Input events
Event related to the digital inputs 1-8.
Example:
!i1c!...#
-> if input 1 is activated (c=close), then the
downstream command will be executed.
!i1o!...#
-> if input 1 is deactivated (o=open), then the
downstream command will be executed.
!i1t!...#
-> if input 1 changes (t=toggle), then the
downstream command will be executed.
8.1.2 !t: Time events
The internal timer of the clock starts counting with zero
seconds, zero minutes and zero hours at the moment the device
is powered up. With insertion of the
-card, this clock is
also set to "0" zero.
Summary of Contents for ProCommander AX
